Volume 6 Issue 3 - January 2016

  • 1. Process parameter optimization of co2 gas cured sodium silicate moulding process for better compression strength.

    Authors : Venkata Ramana Maringanti

    Pages : 549-555

    Keywords : Moulding ,optimization ,compression strength

    Abstract :

    Abstract: As CO2moulding process is used for casting alloys of high density, compression strength of mould should be possibly high. Present paper depicts optimization of process parameters of CO2moulding process for better compression strength. Four process parameters are considered at two levels and Taguchi’s L8 Orthogonal array is used .It is observed that percentage of sodium Silicate and mixing time are the significant factors that affect compression strength. Optimum values of process parameters for maximum compression strength, are obtained and these are validated through confirmation experiments

    Citing this Journal Article :

    Venkata Ramana Maringanti, "Process parameter optimization of co2 gas cured sodium silicate moulding process for better compression strength.", https://www.ijltet.org/journal_details.php?id=898&j_id=2901, Volume 6 Issue 3 - January 2016, 549-555, #ijltetorg